Sponsored Content
Gold Member
Send PMScotch Plains, NJ - USA
Joined: 1/11/2006
Posts: 247
Vette(s): 1981 Corvette Coupe, Stock, Black on Black,
4 Spd
I am atempting to put some of the pieces back on the car.
|UPDATED|7/24/2013 5:39:58 AM (AZT)|/UPDATED|
I can't seem to locate the hole on the top of the dash panel to secure the cable.
Does anyone have any photos or know of any alternate locations for this hole?
I looked from the underside in the car but no hole!
Thanks
|UPDATED|7/24/2013 5:39:58 AM (AZT)|/UPDATED|
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
My cable broke so I had to run a new cable. I went down from the top (under the hood) and attached the new cable to it and pulled it up that way.
Dave
Lifetime Member #116
Dave's '82 
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Lifetime Member
Moderator
Send PMModerator
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 22715
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/
Am-Fm/map light National/Regional/Chapter NCRS "Top Flight"
#2-1985 Bright Red/Carmine Cp.L-98/auto
Member: NCRS, NCRS Texas, Corvette Legends of Texas
I'm lost on this one....I have no clue what cable this is, or where it's s'pose to go.
Is there a larger diagram)or a pic) that shows a little more of the area?
What is the actual function of this cable?
Is this a late model('80-'82) thing only?
Will Lassie finally tell Timmy to go jump in the well?
Joel Adams
C3VR Lifetime Member #56 
My Link 
(click for Texas-sized view!) NCRS
"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Gold Member
Send PMScotch Plains, NJ - USA
Joined: 1/11/2006
Posts: 247
Vette(s): 1981 Corvette Coupe, Stock, Black on Black,
4 Spd
The sheet I referenced is entitled "Fender Reinforcement Cable, YA00 ALL".
It is not a ground cable for sure, measures about 5" long.
Yes, there is another sheet # UPC B01/BO12 Sheet 18 but I don't have it with me.
A photo would help.
Joel, all good questions
|UPDATED|7/24/2013 10:16:06 AM (AZT)|/UPDATED|
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Never heard of this either. Looks like it helps hold up the floor. 
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
My mistake, I thought you meant the hood release cable........never mind.
Dave
Lifetime Member #116
Dave's '82
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Electrical, Body and Interior
Sponsored Content