Sponsored Content
o
Hey I am planning on replacing the engine harness were do you disconnect the harness?. I see were it goes into the back firewall is that were I disconnect it from? Or is it from the inside?
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
Lifetime Member
Moderator
Send PMModerator
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 22720
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/
Am-Fm/map light National/Regional/Chapter NCRS "Top Flight"
#2-1985 Bright Red/Carmine Cp.L-98/auto
Member: NCRS, NCRS Texas, Corvette Legends of Texas
There is a small bolt(5/16" or 3/8") thru the center of the firewall pass-thru there(on the engine side). Take it out, and carefully wiggle the connector loose. That connector is actually two separate harnesses, and you can separate them. One is the "engine" harness, and the other is the "headlight" harness. Adams' Apple 2007-07-23 10:29:12
Joel Adams
C3VR Lifetime Member #56 
My Link 
(click for Texas-sized view!) NCRS
"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
o
Thanks I will look at that today
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Former Member
Send PMManteca, CA - USA
Joined: 11/20/2005
Posts: 3623
Vette(s): 1978,two tone,Metalic Rootbeer & gold
1975 L48 4 speed
You Go Joel !Jimmy B.
Just can't wait to get on the road again. 
Click to see larger views!
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Electrical, Body and Interior
Sponsored Content