Home page

Door adjustment

Forum: C3 Electrical, Body and Interior

4 Messages
Page 1 of 1
Share:
Sponsored Content

Already a Member?

Welcome back! Access your account.

Sign In

Not yet a Member?

Join our community! Registration is free.

Join Free

Door adjustment

Posted: 4/17/06 8:28pmMessage 1 of 4
G
Former Member
Send PM
Joined: 4/17/2006
Posts: 11
I need to adjust the driver's side door to bring the back edge up about a 1/2 inch.  Is the door side or the body side of the hinges adjustable?
Be the first to like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)

Door adjustment

Posted: 4/18/06 9:58amMessage 2 of 4
7
Lifetime Member
Send PM
Montreal, Canada
Joined: 8/6/2004
Posts: 533
Vette(s): Coupe 74 - 454 Drive it like you stole it!
Hummm...  I need to do the same thing on my passenger door as well as the hood (the guy who installed my radiator didn't put the hood back on the lines).
 
I would think that both can be adjusted.  1/2" seems like quite a bit. You door closes right now ?
Be the first to like this post
Sign In to Like this post

Door adjustment

Posted: 4/18/06 12:03pmMessage 3 of 4
Profile Pic
Lifetime Member
Moderator
Send PM
CUYAHOGA FALLS, OH - USA
Joined: 12/2/2003
Posts: 6424
Vette(s): 1975 C3 Red, T-Tops, Black Interior. All I need is time and money! Getting there!

Actually, both adjust.

The hinge on the post will allow some up and down, and in and out.  This will raise or drop the front edge of the door.  If you change one in or out, the back of the door will raise or fall, with the front in the same place.  You also adjust the gaps at the front and rear of the doors.

The adjustment on the door itself allow the door to move inward toward the center of the car, or back out away from the enter.  This allow the door to tilt in or out top and bottom, and line up with the body.

Be the first to like this post
Sign In to Like this post

Door adjustment

Posted: 4/18/06 8:47pmMessage 4 of 4
K
Free Member
Send PM
Piscataway, NJ - USA
Joined: 10/16/2002
Posts: 106
Vette(s): 1973 coupe silver Eng.383 stroker. Tremec 5spd 1977 L48 Stock
  A 1/2" adjustment is quite alot. I would look at the hinge pins and bushings, before making any adjustments. And the worst case is rusted hinge piller.    
Be the first to like this post
Sign In to Like this post
Share:

in Forum: C3 Electrical, Body and Interior


Sponsored Content