Sponsored Content
j
Former Member
Send PMLynn Haven, FL - USA
Joined: 12/8/2007
Posts: 54
Vette(s): 1980 Frame Off Restore, Gun Metal Grey with Dark Red interior. 350 four bolt with forged pistons, Crane Cam, 1990 Tuned Port Injection System, Headman Elite Headers. Fairbanks Automatics, Detroit Locker Rear, High Performance Suspension.
Had my Dash and Dash Wiring Harness Replaced with new and found the Courtesy Lights tucked up under the dash. Have looked everywhere under there and do not see a bracket that they mount on. Please someone point me in the right direction. Thanks.
Live to Cruise 
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
Free Member
Send PMCramerton, NC - USA
Joined: 8/22/2006
Posts: 1094
Vette(s): black 1982 coupe slate gray interior, 350 crossfire, 1985 fuel pump, Steeroids R&P conversion
If they are like mine, the light sockets themselves have a small metal clip which just snaps onto the top of the kick panel.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
j
Former Member
Send PMLynn Haven, FL - USA
Joined: 12/8/2007
Posts: 54
Vette(s): 1980 Frame Off Restore, Gun Metal Grey with Dark Red interior. 350 four bolt with forged pistons, Crane Cam, 1990 Tuned Port Injection System, Headman Elite Headers. Fairbanks Automatics, Detroit Locker Rear, High Performance Suspension.
j
Former Member
Send PMLynn Haven, FL - USA
Joined: 12/8/2007
Posts: 54
Vette(s): 1980 Frame Off Restore, Gun Metal Grey with Dark Red interior. 350 four bolt with forged pistons, Crane Cam, 1990 Tuned Port Injection System, Headman Elite Headers. Fairbanks Automatics, Detroit Locker Rear, High Performance Suspension.
Took a look at the kick panels and there is a wide slot in it but much too wide for the lightclip. Is there supposed to be a metal clip inside the slot? If you or anyone could send a picture or breakdown to show me where it goes I would be eternally greatful. This little dress up project is kicking my butt. Thanks.
Live to Cruise
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Lifetime Member
Moderator
Send PMModerator
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 22716
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/
Am-Fm/map light National/Regional/Chapter NCRS "Top Flight"
#2-1985 Bright Red/Carmine Cp.L-98/auto
Member: NCRS, NCRS Texas, Corvette Legends of Texas
If the light socket has a clip on it, have you tried clipping it to the bottom of the dash, just under the glovebox? I think that's where I've seen them before...
Joel Adams
C3VR Lifetime Member #56 
My Link 
(click for Texas-sized view!) NCRS
"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
j
Former Member
Send PMLynn Haven, FL - USA
Joined: 12/8/2007
Posts: 54
Vette(s): 1980 Frame Off Restore, Gun Metal Grey with Dark Red interior. 350 four bolt with forged pistons, Crane Cam, 1990 Tuned Port Injection System, Headman Elite Headers. Fairbanks Automatics, Detroit Locker Rear, High Performance Suspension.
Yea took a look there first but didn't see anywhere for it to go but maybe I missed it so will look again tomorrow. Thanks for the reply. Will let you know how it turns out.
Live to Cruise
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Electrical, Body and Interior
Sponsored Content