83 collector edition hatch release cable
Forum: C3 Electrical, Body and Interior
5 Messages
Page 1 of 1
Sponsored Content
Just purchase this c3, and having problem with the cable that release that allows the hatch to be open. When the handle is pull, nothing happens.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
First thing I would check is to see if the cables are connected and the latches are functioning. ..................The first cable with the handle on it goes back to the first latch on the drivers side. That latch is connected to the passenger side latch by another cable that goes between the two. Not sure if you have to remove the rear compartment shade or not, but both latches and cables should be visible from underneath the black plastic surround. You'll have to crawl back there and observe while someone pulls the cable. ...................... If both cables and latches are working, make sure both latches are moving far enough to clear the two metal strikes that come down from the glass hatch. ......................... If all that seems to be in order, it might be that your gas shocks are shot and do not have enough ooooomph to raise the glass. ....................... If this seems to be the case, have your assistant pull the cable while you press up from underneath the glass. What ever you do be VERY CAREFUL when opening and closing the hatch !!! That glass is no longer produced and is very expensive to find a new piece. .................... See what the first couple steps above look like and let us know what you find. Good luck !!
|UPDATED|12/16/2015 11:43:12 AM (AZT)|/UPDATED|
|UPDATED|12/16/2015 11:43:12 AM (AZT)|/UPDATED|
John Sigmund

valkman57@sbcglobal.net
NCRS Member 61302
NW NCRS Chapter Member

Duct tape is the new Black !!
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
I check the cable and found the cable had come disconnect from the bracket behind the driver seat. The threads on the plastic portion are worn out and not sure on how I'm going to fix it. Is there anywhere I can get one to replace it.
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Not sure if any of the Corvette suppliers carry much CE stuff. ZIP Corvette has the replacement gas shocks for the hatch but no latch hardware. Your best bet might be EBay, there's usually some CE hatch hardware listed. Just do a search for 1982 Collector Edition. You'll probably also see the $$$ of used hatch glass there. Good luck and keep us posted.
John Sigmund

valkman57@sbcglobal.net
NCRS Member 61302
NW NCRS Chapter Member

Duct tape is the new Black !!
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
I believe the '84 Corvette has the same latch and cable.


Save the Wave!
Support the National Corvette Museum
Support the National Corvette Museum
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: C3 Electrical, Body and Interior
Sponsored Content