Sponsored Content
d
I had damper replaced, cost $770.00, not bad no more noise. saved old damper,called gm for this known problem car has 11,500 miles they said they are replacing some but not with my vin ?????? anyway alls well. dwa175

Be the first to like this post
Sign In to Like this post
Sign In to Like this post
SPONSOR AD:: (Our Sponsors help support Vette Registry)
At that price I'm guessing it's on the 07?
Dampers can cause a LOT of problems up to and including damage to the crankshaft and bearings. The one on my C3 was bad when I got it and was brushing the timing cover. Oddly not enough to make noise, just enough to polish the paint. I found it when I went to set the timing, and the marks were not where they were supposed to be LOL.
Glad it fixed your problem. 

Be the first to like this post
Sign In to Like this post
Sign In to Like this post
d
note I been working on vehicles since 1963 but this damper has no timing marks or key way must be new way of doing things,also note all noises gone.thanks dwa175

Be the first to like this post
Sign In to Like this post
Sign In to Like this post
Lifetime Member
Moderator
Send PMModerator
Duncanville, TX - USA
Joined: 11/8/2003
Posts: 22714
Vette(s): #1-1974 L-48 4spd Cp Med Red Metallic/Black deluxe int w/AC/tilt/tele./p/w-p/b/
Am-Fm/map light National/Regional/Chapter NCRS "Top Flight"
#2-1985 Bright Red/Carmine Cp.L-98/auto
Member: NCRS, NCRS Texas, Corvette Legends of Texas
The balancer is a pres fit...no bolt to hold it on, and also no keyway, which is why it is important to have it installed properly. The engine timing is not mechanically adjustable, so no need for timing marks. The LS series of the Chevy engine is a full departure from what we're used to seeing from previous small blocks.....lots of differences between the two designs. Glad you got it handled, anyway!

Joel Adams
C3VR Lifetime Member #56
My Link
(click for Texas-sized view!) NCRS
"Money can't buy happiness -- but somehow it's more comforting to cry in a CORVETTE than in a Kia"
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
d
new in fo just in GM is going to increase warranty on cluth cyl fully to 10 years this only but also note chevy dealer called and they are going to do same for front dampers stand buy dwa

Be the first to like this post
Sign In to Like this post
Sign In to Like this post
I put a Fluid Damper on my LS engine, plus I have the fixture, drill bit and steel rod to pin the damper to the crank. This way the damper will never spin on the crank. This is very important if you put a supercharger on a LS engine.
GEN III 5.7L "LS6" Engine swap
TKO500 5 spd.
3.54 Dana 44
Be the first to like this post
Sign In to Like this post
Sign In to Like this post
in Forum: All Vettes Discussion
Sponsored Content